A month and a half later I had to send it back because it suddenly stopped working as if the power was constantly resetting the device, quite weird. Just a heads up for anyone experiencing slow speeds, you might want to move it away from other electronics and see if that helps. Asus did and it’s great!!! Perhaps your router’s default password is different than what we have listed here. There are 2 additional ways that you can determine your router’s IP address:. I definitely prefer more open firmware
|Date Added:||26 May 2013|
|File Size:||30.38 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
A few days ago I discovered the signal values reported in the web interface were incredibly low 15 for an access point only a few meters away. I reset the device, swapped the antennas left became right and vice versa restored the configuration and it seemed solved.
If you did not rtl8816 your router’s ip address in the list above. May have been a corrupt saved configuration file. Try single mode G or N or mixed G and N on 2.
Then press the Enter key on your keyboard. Try setting a manual Channel to a open or unused channel. Afterwards I tried swapping the antennas again and it seems like their order influences the bad reception somehow. I got a new one and it seemed to rgl8186 fine.
Try channel 48 or on 5Ghz.
Was a Factory Reset performed before and after any firmware updates then set up from scratch? This isn’t normal behaviour I prefer to use this option OFF.
Preferred security is WPA-Personal. If not I’m not sure whether I will buy a D-Link product in the future Placement on main level floor and central in rttl8186 building and WELL ventilated is preferred.
No console access makes my life harder. After moving the router away from other electronic devices my speeds are back to normal.
What region are you located? What security mode are you using? I tend to save config files with IE or FF only. Look at the sticker under the DAP. Use v3, its free.
I recommend not used saved config files for troubleshooting. I’m using gtl8186 device in client mode only, a handy feature. I updated to the latest firmware but no luck.
Should I contact support or send the device back?
How to Login to the Pluscom WR2-RTL
You may want to follow our guide called Rlt8186 To Reset your Router. Seen other browsers mess up config files on saving. I recommend contacting D-Link and asking about telnet on the back end of this model.
Glad you figured it out.
Incorrect signal values, unwanted RTLdefault SSID on 5G
In this example we’ll use Internet Explorer. Now that you have your router’s Rlt8186 IP Address we are ready to login to it. Please login or register. Found on the DAPs web page under status.