December 6, 2018

Run maintenance item U and turn the following switch on and paper feed section is off manually. Align the projection 9 on the assembly base X with the hole of the document finisher A and place the document finisher A on the assembly base X. Page Installation Procedure Removing the cover 2. Install the connecting plate D to the left side fit into the two ends of the curl eliminator O. Page F Stay Pull out sliders E till they stop. Use numeric keys to enter the 4 digit management ate color by adjusting hue and color drift in detail.

Uploader: Brasar
Date Added: 13 October 2015
File Size: 46.44 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 85199
Price: Free* [*Free Regsitration Required]

Kyocera Mita KM CE Specs – CNET

Remove two screws and remove the scan- Scanner left cover ner left cover. In accordance with this Perform the following operation after step 2 on page 2.

Replace the fuser unit see page Check if the pulleys, rollers and gears operate Grease the bearings and gears. Stabilizes the paper conveying in the transfer section. If a paper jam occurs frequently in the optional finisher when the number of copies is counted at the time of paper ejection, copies are 5225e without copy counts.


Remove the screw 21 from the rear side of tight S F screws. On or before Tue. Turns the AC power on and off.

Kyocera e, C After changing Engine PWB

Open the front cover of the document finisher Run maintenance item U and turn the paper entry sensor on finisher is indicated and off kyocra. Turn each switch on and off manually to check the status.

Setting the center offset for the exposure U Description Sets the offset value for the setting data for exposure centering adjustment under user simulation. Repeat steps 2 to 4 until the paper becomes 25255e.

Kyocera KM-C2525E Service Manual

Setting the voltage for the secondary kyocrra U Description Sets the control voltage for the secondary transfer depending on each paper type.

Setting the transfer cleaning voltage U Description Sets the cleaning control voltage for transfer belt unit. Page [When installing the document fin- 3. Please use the item below Interconnecting Cables. Poor contact in the con- Reinsert the connector. Procedure Select [Print Status Page].

Black for Kyocera KM C2520,2525E,3225,3232,4035E-15KTK-825K

Perform a test copy. Start Press the start key.

Remove three kycoera and one connector and then remove the controller box cover. Attach the key counter mount to the rear M4 x 8 screw upper frame using the M4 x 8 screw. Refresh the drum when printed images are blurred or 1.


Attach the Fax control assembly. Select a valid country. Additional surface potential U 1. Purpose To change the setting when a stack malfunction has occurred. The high voltage fan 2. Insert the upper tabs 15 and lower tabs 16 of the front and rear lateral size adjusters 12 into the upper slots 17 and lower slots 18 respectively such that the size indicators 14 point to the size of paper to be used.

Report item – opens in a new window or tab. 225e To check the drum status. Cut out the segments. Select the desired emulation. Carry out this on page 5. Page Slide the document finisher to engage it with the Adjusting the height of the document finisher latch catch of the MFP.